This is often caused by a clogged drain pump filter, blocked drain hose, or a failing drain pump. We clear the blockage and test the pump and drain cycle.

Common causes include an unbalanced load, worn drive belt, faulty lid switch or door lock, motor issue, or control board fault. We test the safety switches and drive system to confirm the cause.

Leaks can come from cracked inlet hoses, loose clamps, a worn door boot (front load), a bad tub seal, or an overfill issue. We locate the source and repair it to prevent water damage.

Noises are often caused by an unbalanced load, worn shock absorbers, damaged bearings, loose drum, or items stuck in the pump. We inspect and correct the mechanical issue.

Excessive vibration is usually due to leveling problems, overloading, worn suspension parts, or shipping bolts left in place on some units. We level the washer and check the suspension system.

It may be a power issue, faulty door lock or lid switch, control panel problem, or a blown fuse on the control board. We confirm power and safety interlocks first.

This can happen from drainage problems, a failing door lock, water fill issues, overheating motor, or control board errors. We run a test cycle to pinpoint the failure.

Dirty clothes can be caused by wrong cycle settings, overloading, poor water fill, detergent issues, or a washer that is not agitating properly. We check fill level, agitation, and performance.

Common causes include a closed or kinked supply line, clogged inlet screens, a faulty water inlet valve, or a sensor issue. We test water pressure and the valve operation.

Repairs like pumps, valves, belts, door locks, and sensors are often cost effective. If the washer is very old, has major bearing or tub issues, or needs repeated major repairs, replacement may be the better option.